Inspur NF5280M5 User Manual page 55

2.2 Create RAID volume. Select Create RAID Volume option, and press Enter, as shown in the
following figure.
Table 8-2 Create RAID Menu Instruction Table
Interface Parameters Function Description
Please enter a volume name less than 16 characters without containing any special
Name
characters.
Please select the RAID volume level. If no volume has been created at present,
there are four volume levels of RAID0 (Stripe), RAID1 (Mirror), RAID10 (RAID0+1)
and RAID5 (Parity) for selection. Please select the volume level according to actual
requirements.
RAID Level RAID0: This RAID volume is allowed to be made on 2 or above HDDs.
RAID1: This RAID volume is allowed to be made on 2 HDDs.
RAID10: This RAID volume is allowed to be made on 4 HDDs, which is only available
when HDD quantity is 4 or above.
RAID5 (Parity): This RAID volume is allowed to be made on 3 or above HDDs.
Select HDDs to make RAID volume, press Enter, select X, and then press Enter to
Select Disks
return to Create RAID Volume interface.
Strip Size Please select the strip size, only RAID0 and RAID5 volumes could enable this option.
Set the volume capacity, and the maximum capacity is shown in the Help
Capacity
information on the right side.
Create Volume After finishing the above settings, select this option to create RAID volume.
Figure 8-9
Figure 8-10
BIOS Setup
49