Inspur NF5280M5 User Manual page 152

- No more than 64 characters.
9.15.3 SNMP User
SNMP user is used to support SNMP Get/Set, could be created by IPMI CMD or Web GUI.
Default Read Only community: inspur@0531.
●
● For security, SNMP V1/V2c is non-secure, default Disabled.
● SNMPV3 supports user authentication, supported authentication algorithm is SHA and
MD5.
● SNMPV3 supports user privacy , supported privacy algorithm is DES and AES.
Default SNMPV3 user is sysadmin, authentication algorithm is MD5, authentication
●
password is rootuser; privacy algorithm is DES, privacy password is rootuser.
Note: For security, please change default password when you first login, and please change
password periodically.
9.15.3.1 User Security
● SNMPV3 supports user authentication, supported authentication algorithm is SHA and
MD5;
● SNMPV3 supports user privacy, supported privacy algorithm is DES and AES.
9.15.4 Uboot Password
● You can access BMC Uboot by BMC Diagnose Serial Cable.
For security, you cannot access Uboot by default (Password is not set by default).
●
● If you want to access Uboot, you must set a password, then input the password. Contact
our support staff to get changing password method.
Note: For security, please change password periodically if you have set Uboot password.
9.15.5 User Privilege
9.15.5.1 User Privilege for IPMI
BMC has two ways to receive IPMI CMD, out-band and in-band.
Out-band mode means sending IPMI CMD to BMC by LAN, BMC will authenticate user and
●
password.
● In-band mode means sending IPMI CMD in HOST OS. In this mode, IPMI CMD does
146