Dmc Support; Switchable Graphics; Figure 7 Mini Pcie Connector Soldered In Place Of Dmc - Intel 6 Series User Manual

Development Kit Features
3.2.7.2

DMC Support

The development board supports a Display Mini PCIe connector. The three primary
data interfaces defined for PCIe Mini Card are: PCIe, USB and DisplayPort.
On the board,
PCIe port 8 is connected by default to DMC;
•
An option is provided for Display Port D to be connected to DMC. The reworks
•
required on the board are:
o
o
o
o
An option is provided for USB2.0 port 0 to be connected to DMC. For this, the
following reworks have to be done: STUFF R5B12, R5B13, R6A11, R6A12 (with 0
Ohms), UNSTUFF R5B11, R5B14.

Figure 7 Mini PCIe Connector Soldered In Place of DMC

C-link support is also provided for DMC. The reworks required for this are:
•
o
o
3.2.7.3

Switchable Graphics

"Switchable graphics" is a platform feature where you can seamlessly switch between
internal and external graphics modes.
This feature is supported on the 2nd Generation Intel
®
Intel 6 Series Chipset development board via the Elk Creek-4 add-in card (on PEG
slot).
To enable switchable graphics, the J9F4 setting needs to be changed to (2-3). No
board reworks are required.
All display interfaces are from the PCH other than eDP, which is supported via the 2nd
Generation Intel
March 2011
Document Number: 325208-001
UNSTUFF C5A3, C5A4, C5A5, C5A6, C5B3, C5B4, C5B1, C5B2, C5B5,
C5B7
STUFF C5N3, C5N4, C5M4, C5M5, C5N1, C5N2, C5M2, C5M3, C5B6, C5B8
with 0.1 µF cap
The caps unstuffed as shown in UNSTUFF above can be used for those
shown in STUFF, also above
For HPD, UNSTUFF R4A2 and stuff R4A3 with 0 Ohm
UNSTUFF R7C29, R7D1, R7C26
STUFF R7C25, R7C24, R7C23 (with 0 Ohms)
®
Core™ processor family. If one of the DP ports from PCH is to be
nd ®
2 Generation Intel Core™ Processor with Intel
®
Core™ processor family and
®
6 Series Chipset Development Kit
User Guide
37