Fault ( Led1 ); Usb To Uart Activity ( Led2-3 ); Bcm89810 Status ( Led4-6 ) - Analog Devices ADSP-SC573 EZ-KIT Manual

LED22
Figure 3-8: LED Locations
Fault ( )
LED1
When ON, it indicates a system fault. For more information, refer to the ADSP-SC57xHardware Reference Man-
ual.
USB to UART Activity (
The USB to UART activity LEDs are used to indicate the transmitting and receiving of data between a PC and the
USB to UART (FT232R).
Table 3-13: USB to UART LEDs
LED
LED2
LED3
BCM89810 Status (
The BCM89810 status LEDs are used to indicate activity and the speed of the link that was established.
Table 3-14: BCM89810 Status LEDs
LED
LED4
LED5
®
ADSP-SC573 EZ-KIT Manual
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
LED8
)
LED2-3
)
LED4-6
LED3
LED2
Function
Receive
Transmit
Status
10M
100M
LED26
LED25
LED1
LED24
LED23
LEDs
3–15