Jumpers; S/Pdif Loopback ( Jp2 ); Can Inh ( Jp3 ) - Analog Devices ADSP-SC573 EZ-KIT Manual

Table 3-10: Multiple Processor Configuration (Continued)
Location
SW7.5
SW7.6

Jumpers

This section describes functionality of the configuration jumpers. The Jumper Locations figure shows the jumper
locations.
Figure 3-7: Jumper Locations
S/PDIF Loopback (
The S/PDIF loopback jumper is used to connect the S/PDIF input and output signals together and bypass the two
RCA connectors.
CAN INH (
JP3
The CAN INH jumper is used to connect the inhibit output signal from the CAN transceiver to drive the enable/
disable signal to the voltage regulator that powers the boards.
Table 3-11: CAN INH Jumper
Installed Jumper
1 and 2
2 and 3
®
ADSP-SC573 EZ-KIT Manual
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
EZ-KIT connected to emualtor
OFF
ON
JP4
)
JP2
)
P24
JP3
Driver
TJA1055
TJA1145
EZ-KIT not conencted to emulator
ON
OFF
P25
Jumpers
3–13