Debug Interface; Power-On-Self Test - Analog Devices ADSP-SC573 EZ-KIT Manual

• Navigate to the CCES environment through the Start menu. Note that CCES is not connected to the target
board.
• Use the Debug Configurations wizard to connect to the . If a debug configuration exists already, select the ap-
propriate configuration and click Debug.
• To create a debug configuration choose Run > Debug Configurations.
• The Debug Configuration dialog box appears.
• Select Application with CrossCore Debugger and click the 'New' bottom to create a configuration. Then Select
Processor page of the Session Wizard appears.
• Ensure SHARCis selected in Processor family. In Processor type, select ADSP-SC573. Click Next. The Select
Connection Type page of the Session Wizard appears.
• Select Emulator and click Next.
• The Select Platform page of the Session Wizard appears.
• Choose the type of emulator that is connected to the ADSP-SC573 EZ-KIT .
• Click Finish to close the wizard. The new debug configuration is created and added to the Debug Configura-
tions list.
• In the Name edit box, users can select an appropriate name to describe the configuration, otherwise a default
name is provided.
• In the section, choose the program to load (if the appropriate program is not already populated) when connect-
ing to the board. If not loading any program upon connection to the target, do not make any changes.
• While connected to the target, there is no way to choose a program to download. To load a program once
connected, terminate the session and then load the new program.
• To delete a configuration, go to the Debug Configurations dialog box and select the 'Delete' button and choose
Yes when asked if you wish to delete the selected launch configuration. Then Close the dialog box.
• To disconnect from the target board, choose Run > Terminate.
• The default configurations that show up in the CCES Debug Configurations wizard are for JTAG mode de-
bugging only.

Debug Interface

The ADSP-SC573 EZ-KIT provides a JTAG and Traceconnection via

Power-On-Self Test

The Power-On-Self-Test Program (POST) tests all EZ-KIT peripherals and validates functionality as well as connec-
tivity to the processor. Once assembled, each EZ-KIT is fully tested for an extended period of time with POST. All
®
ADSP-SC573 EZ-KIT Manual
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
and .
P1 P5
Debug Interface
2–5