Jtag Interface ( Sw6 And Sw7 ); Adsp-Sc573 Ez-Kit ® Manual - Analog Devices ADSP-SC573 EZ-KIT Manual

Switches
JTAG Interface (
The JTAG Interface switches select between a single processor (one board) and multiprocessor (more than one
board) configurations. By default, the switches are set up for a single EZ-KIT configuration.
Table 3-9: Single Processor Configuration
Location
SW6.1
SW6.2
SW6.3
SW6.4
SW6.5
SW6.6
SW7.1
SW7.2
SW7.3
SW7.4
SW7.5
SW7.6
To use an emulator and multiple EZ-KITs simultaneously set up the boards as shown below. Attach the boards to
each other through connectors
).
and J9
Table 3-10: Multiple Processor Configuration
Location
SW6.1
SW6.2
SW6.3
SW6.4
SW6.5
SW6.6
SW7.1
SW7.2
SW7.3
SW7.4
3–12
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
)
SW6 and SW7
. Connect using the Samtec cables described in
J8 and J9
EZ-KIT connected to emualtor
ON
ON
ON
ON
ON
ON
ON
ON
ON
OFF
Position
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
OFF
EZ-KIT not conencted to emulator
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
OFF
ON
Link Port/JTAG (
J8
®
ADSP-SC573 EZ-KIT Manual