Introduction; Hardware - Mecmesin MultiTest-x Startup Manual

Introduction

Thank you for choosing this Mecmesin console-controlled MultiTest-x test system,
which with correct use will give many years of reliable service.
The stand-alone MultiTest-x has been designed particularly for use in production
areas, which often prove to be unsuitable environments for PC operation. This
flexible, powerful, yet easy-to use system will carry out precise test procedures 'at
the push of a button', then automatically display test results and pass/fail analyses.
However, upon receiving the unit, before attempting to install it and begin testing,
please:
• Check that no obvious physical damage has been sustained by the
packaging material or the test system itself. If any damage is evident,
please notify Mecmesin or an Authorised Agent immediately.
• Before attempting to unpack or move the test system, refer to the safety
advice given in Appendix 2.
• Appendix 1 gives a list of items which should be included with your
system. If any item is missing, please notify Mecmesin or an Authorised
Agent immediately.
It is strongly recommended that all the packaging and fixings be retained for any
future transit requirements. When using the MultiTest-x system please ensure that
the ventilation holes situated on the back and bottom* of the unit are not
obstructed. Also attach (hand tight only) the four rubber feet to the MultiTest-x
system with the screws provided.

Hardware

MultiTest 1-x, 2.5-x and 5-x are single-column test frames with a precision ballscrew
drive. MultiTest 10-x and MultiTest 25-x are twin-column test frames with dual
precision ballscrew drive.
*1-x, 2.5-x and 5-x only
2
Mecmesin MultiTest-x Manual