Mounting Inverter And Expansion Battery Pack - Alpha ESS SMILE-B3-PLUS Installation Manual

MOUNTING

6.3 Mounting Inverter and Expansion Battery Pack

WARNING
Risk of injury due to weight of product
Injuries may be caused if the product is lifted incorrectly or dropped while being transported
or mounted.
Transport and lift the product carefully. Take the weight of the product into account.
Wear suitable personal protective equipment for all work on the product.
CAUTION
Risk of injury due to damaged cables
There may be power cables or other supply lines (e.g., gas or water) routed in the wall.
Ensure that no lines are laid in the wall which could be damaged when drilling holes.
6.3.1 Mounting the SMILE-B3-PLUS
Dimensions of wall bracket (mm)
150
330
725
180
The steps to mount the SMILE-B3-PLUS are listed below:
1. Remove the wall bracket from SMILE-B3-PLUS, place it on the wall where the
system will be installed, and use a marker to locate the bracket.
640
220 134 120
560
470
554
18 19
NOTE:
Considering the battery expansion, the bottom of the wall bracket should
be at least 500 mm above the ground.
2. Drill 8 holes on the wall with Φ10mm drill and insert 8 screw anchors into the drill
holes.
∅
10mm
70mm
3. Attach the wall bracket to the wall and tighten the screws with the tool of SW10
hexagon sleeve.
MOUNTING
≥500mm
M6
SW10