Symbols On The Label - Alpha ESS SMILE-B3-PLUS Installation Manual

SAFETY
WARNING
Risk of chemical burns from electrolyte or toxic gases
During normal operation, no electrolyte would leak from the battery pack and
no toxic gases would form. Despite careful construction, if the battery pack is
damaged or a fault occurs, it is possible that electrolyte may be leaked or toxic
gases may form.
Store the battery pack in a cool and dry place.
Do not drop the battery pack or damage it with sharp objects.
Only set the battery pack down on its back or its bottom.
Do not open the battery pack.
Do not install or operate the battery pack in potentially explosive atmosphere
or areas of high humidity.
If moisture has penetrated the battery pack (e.g. due to a damaged housing),
do not install or operate the battery pack.
In case of contact with electrolyte, rinse the affected areas immediately with
water and consult a doctor without delay.
CAUTION
Risk of burns due to hot heatsink and housing
The heatsink and housing can get hot during operation.
During operation, do not touch any parts other than the cover of the inverter.
NOTICE
Damage to the inverter due to electrostatic discharge
Touching electronic components can cause damage to or destroy the inverter
through electrostatic discharge.
Ground yourself before touching any component.
NOTICE
Damage due to cleaning agents
The use of cleaning agents may cause damage to the product and its components.
Clean the product and all its components only with a cloth moistened with
clear water.
06 07

2.4 Symbols on the Label

Symbols on the type label of the inverter
Symbol Explanation
Beware of a danger zone
This symbol indicates that the product must be additionally grounded if
additional grounding or equipotential bonding is required at the installation
site.
Beware of electrical voltage
The product operates at high voltages.
Beware of hot surface
The product can get hot during operation.
Danger to life due to high voltages in the inverter, observe a waiting time of 5
minutes.
High voltages that can cause lethal electric shocks are present in the live compo-
nents of the inverter.
Prior to performing any work on the inverter, disconnect it from all voltage
sources as described in this document.
WEEE designation
Do not dispose of the product together with the household waste but in
accordance with the disposal regulations for electronic waste applicable at the
installation site.
Observe the documentation
Certified safety
The product is TUV-tested and complies with the requirements of the EU
Equipment and Product Safety Act.
CE marking
The product complies with the requirements of the applicable EU directives.
RCM (Regulatory Compliance Mark)
The product complies with the requirements of the applicable Australian
standards.
SAFETY