Storage; Product Storage; Unpacking; Checking The Outer Packing - Alpha ESS SMILE-B3-PLUS Installation Manual

STORAGE

04 Storage

4.1 Product Storage

The following requirements should be met if the product is not put into use directly:
1. Do not unpack the product.
2. The product should be stored in a clean and dry place and be protected from dust and
water vapor corrosion.
3. Place product according to the signs on the packing case during storage
A maximum of 2 layers can be stacked. To avoid personal injury or device damage, stack
products with caution to prevent them from falling over.
4. Store the product out of reach of children and animals.
5. Handle product with caution to avoid damage.
6. The storage environment requirements are as follows:
– Ambient temperature: -10~55°C, recommended storage temperature: 15~30°C
– Relative humidity: 15%~ 85%
– Place products in a place that is away from corrosive organic solvents and gases.
– Keep products away from direct sunlight.
– Keep products at least 2 meters away from heat sources.
8. The product in storage must be disconnected from external devices. The indica-tors (if
any) on the products should be off.
9. Products should be delivered based on the "first in, first out" rule.
10. The warehouse keeper should collect battery storage information every month and
periodically report the battery inventory information to the planning department. The
batteries that have been stored for nearly 6 months should be recharged timely.
11. If a lithium battery is stored for a long time, capacity loss may occur. After a lithi-um
battery is stored for 12 months in the recommended storage temperature, the
irreversible capacity loss rate is 3%~10%. It is recommended that batteries not be stored
for a long period. If the batteries need to be stored for more than 6 months, it is
recommended to recharge the batteries to 65 ～ 75% of the SOC. For example, they
should be recharged every 6 months at least, and must be recharged to at least 50% of
the SOC.
12 13
05

Unpacking

5.1 Checking the Outer Packing

Before unpacking the battery pack and inverter, check the outer packing for damage,
such as holes and cracks. If any damage is found, do not unpack the product and contact
your distributor as soon as possible.

5.2 Scope of Delivery

Check the scope of delivery for completeness and any externally visible damage.
Contact your distributor if the scope of delivery is incomplete or damaged.
Carton (X1)
6 Pin Terminal Block
(X1)
Screw M5*10 (X2)
Screw M6*16 (X6)
Screw M4*12 (X10)
Cable Box Cover
(X1)
SMILE-B3-PLUS
SMILE-B3-PLUS
Wall Anchor
Wall Bracket (X1)
(X1) ST6*55 (X8)
WiFi Module Terminal Ring Terminal
(X1) Optional Resistor (X1)
Screw M4 (X1) PV CT (X1) Grid CT (X1)
AC Connection Installation
Cover (X1) Manual (X1)
UNPACKING
Cord End
Terminal (X7)
T20 Screwdriver
Lug (X2) (X1)
Holder for Cable
Box Cover (X2)