Table of Contents
Advertisement
oPerAtIng the DevIce
To disable the Surround Thruput function:
►
Select AUX 2 / SURR .
The LED (1) above the input selector key lights orange .
►
Turn the volume level control (5) fully counterclockwise .
►
Turn off the Source connected to AUX 2 / SURR .
►
Move the slide switch (14) on the rear to the left .
The LED (1) above the input selector key lights green .
The function is now disabled .
Remote output
If a REMOTE DC OUT connector on the integrated amplifier is connected to the
remote input on a BURMESTER component, this component is switched on and off
together with the integrated amplifier .
Protective functions
The integrated amplifier is equipped with extensive protection circuits that protect the
amplifier and the connected speakers from being damaged in the case of an error .
If an error, such as overheating, DC offset, or overcurrent occurs, the device switches
the corresponding speaker outputs off and enters standby mode .
The LED (operation/standby) flashes in red .
Eliminating the error:
1 .
Reduce the volume at the signal source .
2 .
Check the integrated amplifier output connections to the speakers .
3 .
Allow the integrated amplifier to cool down and then switch it back on using the
power on/off switch (8) or the remote control .
If the error persists, please contact your specialist dealer .
22
Advertisement
Table of Contents
