Table of Contents
Advertisement
Chapter 7
Replacement Procedures
Follow the procedures in this section when you need to replace the parts listed
below:
• Battery for battery-backed RAM
• Control board
• Display board and seven-segment LEDs
• Fan
• Footswitch board
• Front panel
• Front panel components, including the REM module and power switch
• Fuses, including two in the fuse drawer and one on the Power Supply/RF board
• Heat sinks (left front, left rear, and right heat sinks) and associated heat sink
components
• Low voltage power supply
• Power entry module
• Power Supply/RF board.
For your reference, this section also includes an electrical cable interconnect
diagram that illustrates all cable connections.
The parts used in these procedures are illustrated in Chapter 9, Service Parts.
7-1
Force FX Electrosurgical Generator C Service Manual
Advertisement
Table of Contents
