Figure 10-6 Keypad Cable Secured By Locking Bar - Covidien WarmTouch Service Manual

Place the unit on its back. Remove the strap or cable tie from the handle, and re-
10.
open the unit.
On the UI PCBA, slide the locking bar up from the J204 connector, and slide the
11.
keypad cable completely into the connector in front of the locking bar. Press down
on both sides of the locking bar to secure the cable. The locking bar must be com-
pletely seated on both sides
Follow the procedure
12.
Perform the following tests:
13.
a.
b.
Service Manual
Figure 10-6. Keypad Cable Secured by Locking Bar
Rejoining the Front and Rear Enclosures
Keypad Test on page 7-5.
Electrical Safety Tests on page 7-14.
(Figure 10-6).
Keypad Replacement
on page 9-5.
10-7