Installation And Disassembly Of The Frame And Tarpaulin Cover - PRONAR T669 Operator's Manual

SECTION 5
ATTENTION!
When operating the trailer, pay close attention to proper installation of wall extensions,
securing of individual segments, and make sure that any loose nuts are tightened.
DANGER
Assembly and disassembly of wall extensions should be carried out with the use of
appropriate platforms, ladders or when standing on a ramp. These tools must be in good
condition to fully protect the persons working on them against falling. Work should be
performed by at least two persons.
Exercise particular caution.
5.12 INSTALLATION AND DISASSEMBLY OF THE FRAME
AND TARPAULIN COVER
Tarpaulin cover can only be used together with the frame. The assembly of wall extensions
should be carried out with the use of appropriate platforms, ladders, ramps or other stable
raised surfaces. Particular care should be taken, holding onto the trailer with one hand. Work
should be done with the help of another person
The frame structure comprises front apex (1), centre apex (2), rear apex (3), as well as
connecting pipe (4) – figure (5.15).
Assembly of frame and tarpaulin
Attach front apex (1) to the front wall extension.
Attach rear apex (3) o the rear wall extension.
Attach centre apex (2) to lateral stakes.
Screw the connecting pipe (3) to the front and centre apexes
Install limiters (5) to side wall extensions on the right side of the load box.
Place tarpaulin cover (6) so that it rests on the limiters on the right side.
The tarpaulin should be laid so that it is possible to one role it without
unnecessary laying of material.
5.39
Pronar T669