Lubricants; Cleaning Trailer - PRONAR T669 Operator's Manual

SECTION 5
with the use of carbon dioxide, foam or extinguisher steam. Do not use water to quench oil
fires.

5.7.2 LUBRICANTS

For parts under great load it is recommended to apply lithium grease with molybdenum
disulphide (MOS ) or graphite additive. In the case of less loaded sub-assemblies the
2
application of general purpose machine greases is recommended, which contain
anticorrosion additive and have significant resistance to being washed away by water. Similar
characteristics should typify aerosol preparations (Silicon greases and anticorrosive lubricant
substances).
Before starting to use greases acquaint oneself with the content off the information leaflet for
the chosen product. In particular, the principles of safety and handling of the lubricant and
method of disposal (waste containers, contaminated rags, etc.) are essential. Information
leaflet (product sheet) should be stored together with the grease.

5.8 CLEANING TRAILER

Trailer should be cleaned depending on requirements and before longer idle periods (e.g.
before winter period). Before using pressure washer the user is obliged to acquaint himself
with the operating principles and recommendations concerning safe use of this equipment.
Trailer cleaning guidelines
• Before cleaning the trailer open the tailgate. Carefully clean load remains from the
load box (sweep out or blow out with compressed air), especially where tailgate
and extensions join together.
• To clean trailer only use clean running water or water with a cleaning detergent
additive with neutral pH.
• Using pressure washer increases washing effectiveness, but particular care must
be taken during work. During washing washer nozzle may not be closer than 50
cm from the surface being cleaned.
• Water temperature shall not exceed 55°C.
5.33
Pronar T669