Table of Contents
Advertisement
Pronar T386
In the event of necessity of changing hydraulic oil for another oil, check the recommendations
of the oil Manufacturer very carefully. If it is recommended to flush the system with the
appropriate preparation, then comply with these recommendations. Attention should be
given, so that chemical substances used for this purpose do not damage the materials of the
hydraulic system. During normal trailer use change of hydraulic oil is not necessary, but if
required, this operation should be entrusted to a specialist service point.
TABLE 5.6
L-HL 32 Lotos hydraulic oil characteristics
ITEM
1
ISO 3448VG viscosity classification
2
Kinematic viscosity at 40°C
3
ISO 6743/99 quality classification
4
DIN 51502 quality classification
5
Ignition temperature
Because of its composition the oil applied is not classified as a dangerous substance,
however long-term action on the skin or eyes may cause irritation. In the event of contact of
oil with skin wash the place of contact with water and soap. Do NOT apply organic solvents
(petrol, kerosene). Contaminated clothing should be changed to prevent access of oil to skin.
In the event of contact of oil with eye, rinse with large quantity of water and in the event of the
occurrence of irritation consult a doctor. Hydraulic oil in normal conditions is not harmful to
the respiratory tract. A hazard only occurs when oil is strongly atomised (oil vapour), or in the
case of fire during which toxic compounds may be released. Oil fires should be quenched
with the use of carbon dioxide, foam or extinguisher steam. Do not use water to quench oil
fires.
5.8.2 LUBRICANTS
For parts under great load it is recommended to apply lithium grease with molybdenum
disulphide (MOS
) or graphite additive. In the case of less loaded sub-assemblies the
2
application of general purpose machine greases is recommended, which contain
anticorrosive additives and have significant resistance to being washed away by water.
Aerosol preparations (silicon greases and anticorrosive-lubricating substances) should have
similar characteristics.
NAME
5.38
SECTION 5
UNIT
VALUE
-
32
2
mm
/s
28.8 – 35.2
-
HL
-
HL
C
230
Advertisement
Table of Contents
