Taylor 810 Series Original Service Instructions page 47

7. Using the keyboard displayed on the control, enter a
file name to save the menu item. The name can have
up to eight characters and must have no spaces in
the name. Pressing the OK key will save the menu
item to the USB flash drive. Press the EXIT key three
times to return to the menu item screen.
8. Remove the USB flash drive from the USB port and
re-install the USB cable cap on the USB connector.
Loading Menu Items from USB
Once the proper software is loaded on the USB flash
drive, the next control board can be programmed from
the USB flash drive.
1. Repeat step 1 through step 5 from "Loading Store
Menu Items to USB."
2. Press the LOAD MENU FROM USB key.
Controls and Systems
3. The control can display up to 40 different menu
options loaded on the USB flash drive. Select the key
for the correct menu to load. The control will display
DONE at the bottom of the screen when the menu is
loaded. Press the EXIT key twice to return to the
menu item screen.
4. Remove the USB flash drive from the USB port and
re-install the USB cable cap on the USB connector.
5. To load menu items from the USB flash drive to
another control board, repeat these software loading
procedures.
Note: Grills built prior to serial number M1035495
will require the front control panel to be re-installed.
Model 810, 812, 820, 822, 828 Series
CONTROLS AND SYSTEMS
2
2-17