Advantech ADAM 4000 Series User Manual page 89

Table 4.9: ADAM-4024 Command Table
Clear 4mA Calibra-
$AAPCn
tion Parameter
Clear 20mA Calibra-
$AAQCn
tion Parameter
Watchdog Timer
$AAX0nnnn
Setting
Read Watchdog
$AAX1
Timer Setting
#** N/A
$AA0Cn 4 mA Calibration
Table 4.10: ADAM-4050 Command Table
Command Syntax Command Name
%AANNTTCCFF Configuration
$AA6 Digital Data In
#AABB(data) Digital Data Out
Synchronized
#**
Sampling
Read Synchronized
$AA4
Data
$AA2 Configuration Status
$AA5 Reset Status
Read Firmware
$AAF
Version
$AAM Read Module Name
Clear CHn 4mA Calibration
Parameter/EEPROM
Clear CHn 20mA Calibration
Parameter/EEPROM
Set communication W DT cycle time
from 0000 ~ 9999 (unit: 0.1 second. if
value is 0000, the communication W
DT function will be disable)
Read the cycle time setting of com-
munication W DT
Synchrous Sample IDI
Tells the module to store parameters
for 4 mA Calibration
Command Description
Sets address, baud rate, and/or
checksum status, to a digital I/O mod-
ule
Returns the values of the digital I/O
channels of the addressed module
Writes specified values to either a
single channel or all channels simul-
taneously
Orders all digital I/O modules to
sample their input values and store
them in a special register
Return the value of a specified digital
I/O module that was stored after an
#** command was issued
Returns the configuration parame-
ters of a specified digital I/O module
Indicates whether a specified digital
I/O module was reset after the last
time the $AA5 command was issued
Return the firmware version code
from the specified digital I/O module
Return the module name from the
specified Digital I/O module
77 ADAM-4000 Series User Manual
6-21
6-21
6-21
6-21
6-20
6-20
Page No.
7-4
7-6
7-8
7-11
7-12
7-14
7-16
7-18
7-19