Main work
–
Remove screws
dlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Position rubber bushings
below.
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
Guideline
Screw, handlebar
H01189-10
support
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamp.
–
1
Mount screws
–
First bolt the handlebar clamp with screws
higher side of the handlebar supports so that both parts touch.
Guideline
Screw, handlebar
clamp
–
Tighten screws
Guideline
Screw, handlebar
clamp
Finishing work
–
Mount the handlebar cushion.
TUNING THE CHASSIS 10
1
. Remove the handlebar clamp. Remove the han-
2
. Take off handlebar supports
4
and push through nuts
2
.
M10
40 Nm (29.5 lbf ft)
but do not tighten yet.
1
M8
20 Nm (14.8 lbf ft)
1
evenly.
M8
20 Nm (14.8 lbf ft)
3
.
5
from
Loctite
®
243™
onto the longer,
41