Preparing The Vehicle For Rides On Dry Sand - GAS GAS MC 125 2022 Owner's Manual

7 PREPARING FOR USE
»
–
Make sure that no radiator covers are installed.
Difficult operating conditions are:
–
–
–
–
–
7.4
20
If humidity, corrosion, or damage is found:
–
Clean and dry the connector, or change it if necessary.
Rides on dry sand. ( p. 20)
Rides on wet sand. ( p. 21)
Rides on wet and muddy circuits. (
Riding at high temperatures or slow riding. (
Riding at low temperatures and in snow. (

Preparing the vehicle for rides on dry sand

M01129-01
M01104-01
M01105-01
p. 22)
p. 23)
p. 24)
–
Check the radiator cap.
Value on the radiator cap
» If the indicated value does not correspond to the setpoint value:
Warning
Danger of scalding During motorcycle operation,
the coolant gets very hot and is under pressure.
–
Do not open the radiator, the radiator hoses or
other cooling system components if the engine
or the cooling system are at operating temper-
ature.
–
Allow the cooling system and the engine to
cool down before you open the radiator, the
radiator hoses or other components of the
cooling system.
–
In the event of scalding, rinse the area affected
immediately with lukewarm water.
–
Change the radiator cap.
–
Mount the air filter dust cover.
Air filter dust cover (79006920000)
Info
Observe the fitting instructions for GASGAS Techni-
cal Accessories.
–
Mount the air filter sand cover.
Air filter sand cover (79006922000)
Info
Observe the fitting instructions for GASGAS Techni-
cal Accessories.
1.8 bar (26 psi)