GAS GAS MC 125 2022 Owner's Manual page 87

Main work
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease shaft seal rings
spacers.
Long-life grease (
–
Insert the spacers.
H03001-10
–
Clean and grease the wheel spindle.
Long-life grease (
–
Position rear wheel and insert wheel spindle
The brake linings are correctly positioned.
–
Mount the chain.
H00006-10
–
Position chain adjuster
–
Make sure that chain adjusters
5
screws .
–
Check the chain tension. (
–
4
Tighten nut
Guideline
Nut, rear wheel spindle
Info
The wide adjustment range of the chain adjusters (32 mm
(1.26 in)) enables different secondary ratios with the same
chain length.
Chain adjusters
–
Operate the foot brake lever repeatedly until the brake linings are in
contact with the brake disc and there is a pressure point.
H00007-10
Finishing work
–
Remove the motorcycle from the lift stand. (
1
and contact surfaces
p. 122)
p. 122)
2
3 4
. Mount nut , but do not tighten it yet.
3
are fitted correctly on adjusting
p. 62)
.
M25x1.5 80 Nm (59 lbf ft)
3
can be turned by 180°.
WHEELS, TIRES 13
A
of the
.
p. 42)
85