GAS GAS MC 125 2022 Owner's Manual page 77

Warning
Danger of accidents Brake linings which have not been approved alter the braking efficiency.
Not all brake linings are tested and approved for GASGAS motorcycles. The structure and friction coefficient of the
brake linings, and thus their brake power, may vary greatly from that of original brake linings.
If brake linings are used that differ from the original equipment, compliance with the original homologation is
not guaranteed. In this case, the vehicle no longer corresponds to its condition at delivery and the manufacturer
warranty shall be void.
–
Only use brake linings approved and recommended by GASGAS Motorcycles.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the appli-
cable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid corrodes paint.
Only use clean brake fluid from a sealed container.
–
Move the brake fluid reservoir mounted on the handlebar to a hori-
zontal position.
–
Remove screws
–
2
Take off cover
–
Manually press the brake caliper toward the brake disc to push back
the brake pistons. Ensure that brake fluid does not flow out of the
brake fluid reservoir, extract some if necessary.
Info
K00469-10
Make sure that you do not press the brake caliper against
the spokes when pushing back the brake pistons.
–
Remove cotter pins
ings.
–
Clean the brake caliper and the brake caliper bracket.
101737-10
–
Check that spring plate
7
ing plate in the brake caliper bracket are seated correctly.
100397-01
1
.
3
with membrane .
4 5
, pull out pin , and remove the brake lin-
6
in the brake caliper and brake pad slid-
BRAKE SYSTEM 12
75