GE Voluson P8 Basic Service Manual page 401

GE DRAFT
DIRECTION 5775469, R
8.) By using spanner, unscrew the nut of encoder to be replaced. And replace the encoder. Refer to
the figures below.
9.) Pull the encoder out from the main keyboard circuit board. Refer to the figure below.
Figure 8-45 Pulling the encoder out from the main keyboard circuit board
8-15-4 Installation Procedure
Install a new part in the reverse order of removal procedure.
3 DRAFT (J
EVISION
Figure 8-44 Unscrewing the nut of encoder to be replaced
Chapter 8 - Replacement Procedures
19, 2018)
ULY
V ™ P8/V
OLUSON OLUSON
B S M
ASIC ERVICE ANUAL
™P6
8-39