Stand-Alone Voluson™ P8/Voluson™P6; Voluson™ P8 / Voluson™P6 + Pc (With 4D View Software) Within A; Sneaker Net; Connection Between Voluson™ P8/Voluson™P6 And Dicom Server - GE Voluson P8 Basic Service Manual

GE RAFT
DIRECTION 5775469, R
3-11-1-3 Stand-alone Voluson™ P8/Voluson™P6
If digital images or 3D/4D data sets are stored, they should be saved in the Archive (Image Management
System software).
For Image Management functionality refer to the Basic User Manual of the Voluson™ P8/Voluson™P6.
To avoid loss of essential data, it is highly recommended to export/backup patient data as well as
NOTICE
measurements at least once a month.
!! NOTICE:
Physical Connection:
No network connection needed.
3-11-1-4 Voluson™ P8/Voluson™P6 + PC (with 4D View Software) within a "Sneaker Net"
A PC (one or several with 4D View software installed) is used for review and work on studies acquired
on one or more Voluson™ P8/Voluson™P6 System without being connected in a network.
The images are first stored on the Voluson™ P8/Voluson™P6 System 's hard drive (Archive) and then
exported from the System 's hard drive to a sneaker device (e.g., DVD/CD), and finally imported from
the sneaker device to the "4D View" PC's internal hard drive.
For Image Management functionality refer to the Basic User Manual of the Voluson™ P8/Voluson™P6.
To avoid loss of essential data, it is highly recommended to export/backup patient data as well as
NOTICE
measurements at least once a month.
!! NOTICE:
Physical Connection:
No network connection needed.
3-11-1-5 Connection between Voluson™ P8/Voluson™P6 and DICOM Server
In this configuration, the Voluson™ P8/Voluson™P6 is configured to work with a DICOM server in a
network environment. Usually, this will be the hospital network. Images are first saved on the local
image buffer on the System . At the end of the examination, the images are sent to the DICOM server
via a DICOM spooler. This scenario requires that the System is configured to be connected to the
DICOM server.
Physical Connection:
You will need one network cable.
1.) Connect one end of the cable to the Ethernet connector on the Voluson® P8 / Voluson® P6.
2.) Connect the other end of the cable to the wall outlet.
NOTE: If a Peer-to-Peer Network is connected to the hospital's network, you may connect the
Voluson™ P8/Voluson™P6 to the Peer-to-Peer Network.
For more details refer to
3-70
3 DRAFT (J
EVISION
Figure 3-12-2 on page 3-73
Section 3-11 - Connectivity Setup
19, 2018)
ULY
V ™ P8/V
OLUSON OLUSON
B S M
ASIC ERVICE ANUAL
™P6