GE Voluson P8 Basic Service Manual page 308

GE RAFT
DIRECTION 5775469, R
7-4-3 Export Log's and System Data
There are two possibilities to export system data (and log´s):
1.) by pressing the ALT + D key to save a snapshot and "Full Backup" of the System state;
see:
2.) via the EXPORT SYSTEM DATA button in the System Setup - Administration -
see:
7-4-3-1 Export System Data (by pressing the ALT + D key)
ALT + D uses "Full Backup" to gather data from the system. In addition it creates one screenshot
(Alt-D.bmp) of the point in time when ALT + D was pressed.
The main use is when R&D or OLC need detailed information about the system (e.g., when
experiencing strange behaviour or when the problem should be investigated by R&D).
It is not intended to replace or enhance the existing Full Backup functionality.
NOTE: The Full Backup created by Alt + D was pressed. The main use is when R&D or OLC need detailed
information about the system (e.g., when experiencing strange behaviour or when the problem shoud
be investigated by R&D). It is intended to replace or enhance the existing Full Backup functionality.
Data can be stored on the hard disk (D:\export\fullbackup\fb1), or you can export them to DVD/CD.
Including the D:\export folder, which contains dump files (for details see:
Process Logger files, Autotester files, SMART logs and Screenshots [Alt + P].
NOTE: Successive ALT + D keystrokes overwrite existing snapshots (Alt-D.bmp) at destination HDD.
1.) Press the ALT + D key on the keyboard simultaneously.
2.) Select whether you wnat to backup data with our without hardware diagnosis tests.
Please detach all probes if you want to execute hardware diagnosis, then click Yes.
NOTICE
7-16
3 DRAFT (J
EVISION
7-4-3-1 on page 7-16
7-4-3-2 on page 7-18
Figure 7-14 "Alt - D" backup
Section 7-4 - Screen Captures and Logs
19, 2018)
ULY
V ™ P8/V
OLUSON OLUSON
B S M
ASIC ERVICE ANUAL
page;
SERVICE
Section 7-4-3-2-1),
™P6