Front Brake Installation - Argon 18 E-119 TRI+ 284A Assembly Manual

E-119 TRI+ 284A: 9. Front Brake Installation
1. Install brake arms on the fork over the 2mm washer.
Make sure brake arms can rotate loosely once pivot bolts
are fully tightened (7Nm).
Install brake arms without brake pads. Install brake arm
with spring stopper facing inward. Once brake arms are
fi xed, rotate them in order to have spring stopper pin facing
outward.
2. Choose the desired position of the handlebar: high
(+2.5cm) or low (-2.5cm).
For easier assembly, install front brake housing inside
handlebar before fi xing handlebar on the stem.
3. Measure approx. 32cm length of CGX housing.
4. Clean housing ends to avoid cable friction and thread
through handlebar.
GREASE
+ 2.5cm
7Nm
7Nm
- 2.5cm
15