Argon 18 E-119 TRI+ 284A Assembly Manual page 28

E-119 TRI+ 284A: 11. Rear Brake Installation
Note: For the E-119 Tri+, the bottom bracket guide rear brake section is not needed, the housing will by-pass and attach directly to the rear brake assembly.
Handlebar Section
outer
side
1. Determine if there is a need for a metal cap at the lever (e.g.: Shimano no, TRP yes).
2. Measure approx. 400mm length of the gray E-Z Bend housing so the handlebar rotates without restrictions.
3. Install the brake lever according to manufacturer's recommendations.
4. Pass the brake cable inside the lever and route it so it comes out the middle section parallel to the handlebar.
5. Install the housing with the cable inside the handlebar.
E-Z Bend
KEB
27