Argon 18 E-119 TRI+ 284A Assembly Manual page 19

E-119 TRI+ 284A: 9. Front Brake Installation
12. Thread cable through the wedge with the nut
wedge
facing the front of the bike.
13. Place the brake and rollers onto wedge "home"
position.
14. To secure cable, pre-tighten cable clamp bolt
with 8mm fl at wrench. Avoid moving the wedge on
the cable and remove the wedge from the brake
arms.
15. Using a 13mm fl at wrench to hold the wedge in
place, complete tightening on cable clamp bolt to
6Nm.
16. Make sure cable clamp bolt head is positioned
so that 1 through hole is vertically aligned.
Brake
home position
6Nm
18