Seat Post Clamp Installation - Argon 18 E-119 TRI+ 284A Assembly Manual

E-119 TRI+ 284A: 4. Seat Post Clamp Installation
RUNNING CHANGE
5.5 Nm
GREASE
1. Apply a drop of blue Threadlocker
(n. 242) on the bolt's thread
2. Apply grease on the seat post clamp
1.7.1
and on the screws as shown
GREASE
3. Assemble the seat post clamp with the
GREASE
small screw, allowing the parts to move
freely
4. Place the seat post collar inside the
LOCTITE
frame, holding it to prevent it falling
inside the frame
1Nm
5. Insert the seatpost, on which some
CARBON FIBER
carbon fiber assembly paste has been
ASSEMBLY
COMPOSITE
applied
6. Position the seatpost to the desired
height
7. Tighten the set screw at max. 5.5Nm
IMPORTANT : The E-119 Tri+'s seat clamp
is not the same as the Nitrogen
5