Argon 18 E-119 TRI+ 284A Assembly Manual page 24

E-119 TRI+ 284A: 10. Handlebar Installation
For an inclined position, use the swivel
assembly (4.2).
STEP 1: Swivel assembly content:
1- Connector base (4.12.1)
2- Swivel spacer (4.2.1 + 4.2.2)
3- Swivel screw (4.2.4)
4- Swivel square nut (4.2.3)
Assemble the unit and leave it
unscrewed, just enough to allow
adjustment and to turn the swivel 90
degrees in order to have access to the
sleeve nuts (4.8) and fi x the socket
head screw at 4Nm.
Tighten swivel screw (4.2.4) to 8Nm.
Note:
The connector base must be fi xed to the
top of the swivel assembly, not on the
sleeve nuts.
4Nm
4Nm
GREASE
4Nm
GREASE
4.12.1
LOCTITE
8Nm
4.2.4
4.2.2
4Nm
GREASE
GREASE
4.2.1
4.2.3
4.1
4Nm
4Nm
GREASE
GREASE
4.15
4.16
CARBON FIBER
ASSEMBLY PASTE
4.18
4.8
4.12.2
4.2
23