Taking Acquisitions With The Cerec Omnicam - Dentsply Sirona CEREC AC Connect Operating Instructions Manual

Dentsply Sirona
Operating Instructions CEREC AC Connect
64 32 087 D3492
D3492.201.07.24.02 07.2018

Taking acquisitions with the CEREC Omnicam

7.3
CAUTION
Hot surface!
The coated sapphire layer of the CEREC Omnicam is preheated in
the camera cradle. When removing the CEREC Omnicam from its
cradle, the surface temperature of the mirror sleeve can be up to
51°C. This may cause an unpleasant heat sensation on contact with a
person's skin or mucous membrane. These temperatures will not
damage the skin or mucosal membrane.
After removing the CEREC Omnicam from the camera cradle, the
temperature of the mirror sleeve drops within a few minutes (< 5
minutes) to less than 43°C. The CEREC Omnicam is therefore
suitable for use in the patient's mouth for an unlimited period of time.
At an ambient temperature from 30°C, only select the three lower
heater settings.
NOTE
Image brightness
The image brightness during the acquisition is controlled
automatically, so that there is always optimum image brightness,
largely independent of the distance between the CEREC Omnicam
and the tooth.
The surroundings of the tooth to be scanned should be as weakly
illuminated as possible. Avoid any type of external light. Switch off the
operating light.
IMPORTANT
Do not use cotton rolls in the scan area
Do not use any cotton rolls in the vicinity of the scan area.
Should any pieces of cotton roll contaminate this area, the
acquisitions will be inaccurate.
CAUTION
Prevent cross-contamination
Germs can be transmitted to uncontaminated persons via the hands,
materials or objects.
➢ For hygiene reasons, wear a new set of disposable gloves for
each patient while using the CEREC Omnicam.
CAUTION
In the case of patients with allergies to nickel
Should the CEREC Omnicam mirror sleeve make contact with the
skin of patients allergic to nickel, allergic reactions may occur.
➢ Ensure that in the case of patients with nickel allergies, the parts
of the CEREC Omnicam mirror sleeve which may make contact
are protected from areas of skin.
7.3 Taking acquisitions with the CEREC Omnicam
7 Operation
41