General - Fortinet FortiWiFi FortiWiFi-60 Administration Manual
Antivirus firewalls
Hide thumbs
Also See for FortiWiFi FortiWiFi-60:
- Installation and configuration manual (76 pages) ,
- Quick start manual (2 pages) ,
- Administration manual (458 pages)
Table of Contents
Advertisement
Router
General
FortiWiFi-60 Administration Guide
RIP is a distance-vector routing protocol intended for small, relatively homogeneous,
networks. RIP uses hop count as its routing metric. Each network is usually counted
as one hop. The network diameter is limited to 15 hops.
Figure 61: RIP General settings
RIP Version
Enable sending and receiving RIP version 1 packets, RIP version 2
packets, or both for all RIP-enabled interfaces. You can override this
setting on a per interface basis. See
Default Metric
For non-default routes in the static routing table and directly connected
networks the default metric is the metric that the FortiWiFi unit advertises
to adjacent routers. This metric is added to the metrics of learned routes.
The default metric can be a number from 1 to 16.
Enable Default-
Advertise a default static route into RIP.
information-
originate
RIP Timers:
RIP timer defaults are effective in most configurations. All routers and
access servers in the network should have the same RIP timer settings.
Update
The time interval in seconds between RIP updates.
Garbage
The time in seconds that must elapse after the timeout interval for a route
expires, before RIP deletes the route. If RIP receives an update for the
route after the timeout timer expires but before the garbage timer expires
then the entry is switched back to reachable.
Timeout
The time interval in seconds after which a route is declared unreachable.
The route is removed from the routing table. RIP holds the route until the
garbage timer expires and then deletes the route. If RIP receives an
update for the route before the timeout timer expires, then the timeout
timer is restarted. If RIP receives an update for the route after the timeout
timer expires but before the garbage timer expires then the entry is
switched back to reachable. The value of the timeout timer should be at
least three times the value of the update timer.
Redistribute:
Advertise routes learned from static routes, or a direct connection to the
destination network.
Connected
Advertise routes learned from directly connected networks.
Metric
Enter the metric to be used for the redistributed connected routes.
01-28006-0014-20041105
"Interface options" on page
RIP
156.
153
Advertisement
Table of Contents
