Fortinet FortiWiFi FortiWiFi-60 Administration Manual page 99

System config
FortiWiFi-60 Administration Guide
Figure 35: HA network configuration
Internal Network
Hub or
Switch
2 Power on all the FortiWiFi units in the cluster.
As the units start, they negotiate to choose the primary cluster unit and the
subordinate units. This negotiation occurs with no user intervention and normally just
takes a few seconds.
You can now configure the cluster as if it is a single FortiWiFi unit.
To add a new unit to a functioning cluster
1 Configure the new FortiWiFi unit for HA operation with the same HA configuration as
the other units in the cluster.
2 If the cluster is running in Transparent mode, change the operating mode of the new
FortiWiFi unit to Transparent mode.
3 Connect the new FortiWiFi unit to the cluster.
4 Power on the new FortiWiFi unit.
When the unit starts it negotiates to join the cluster. After it joins the cluster, the cluster
synchronizes the new unit configuration with the configuration of the primary unit.
Internal
PWR
PWR
Internal
01-28006-0014-20041105
WAN1
INTERNAL
WLAN 1 2 3 4 DMZ WAN1 WAN2
LINK 100 LINK 100 LINK 100 LINK 100 LINK 100 LINK 100 LINK 100
DMZ
Hub or
Switch
DMZ
INTERNAL
1 2 3 4 DMZ WAN1 WAN2
WLAN
LINK 100 LINK 100 LINK 100 LINK 100 LINK 100 LINK 100 LINK 100
WAN1
Internet
HA
Router
99