Transparent Mode Route Settings - Fortinet FortiWiFi FortiWiFi-60 Administration Manual
Antivirus firewalls
Hide thumbs
Also See for FortiWiFi FortiWiFi-60:
- Installation and configuration manual (76 pages) ,
- Quick start manual (2 pages) ,
- Administration manual (458 pages)
Table of Contents
Advertisement
Routing table (Transparent Mode)
Transparent mode route settings
58
Create New Select Create New to add a new route.
#
Route number.
IP
The destination IP address for this route.
Mask
The netmask for this route.
Gateway
The IP address of the next hop router to which this route directs traffic.
Distance
The the relative preferability of this route. 1 is most preferred.
Delete icon. Select to remove a route.
View/edit icon. Select to view or edit a route.
Move To icon. Select to change the order of a route in the list.
Figure 13: Transparent mode route options
Destination IP
Enter the destination IP address and netmask for this route.
/Mask
Gateway
Enter the IP address of the next hop router to which this route directs traffic
Distance
The the relative preferability of this route. 1 is most preferred.
To add a Transparent mode route
1
Go to System > Network > Routing Table.
2
Select Create New to add a new route.
3
Set the Destination IP and Mask to 0.0.0.0.
For the default route, set the Destination IP and Mask to 0.0.0.0.
Note: Only one default route can be active at a time. If two default routes are added to the
routing table, only the default route closest to the top of the routing table is active.
4
Set Gateway to the IP address of the next hop routing gateway.
For an Internet connection, the next hop routing gateway routes traffic to the Internet.
5
Select OK to save the route.
01-28006-0014-20041105
System network
Fortinet Inc.
Advertisement
Table of Contents
