Fortiwifi Traps - Fortinet FortiWiFi FortiWiFi-60 Administration Manual

SNMP

FortiWiFi traps

108
The FortiWiFi agent can send traps to SNMP managers that you have added to
SNMP communities. For SNMP managers to receive traps, you must load and
compile the Fortinet trap MIB (file name fortinet.trap.2.80.mib) onto the SNMP
manager.
All traps include the trap message as well as the FortiWiFi unit serial number.
Table 9: Generic FortiWiFi traps
Trap message
ColdStart
WarmStart
LinkUp
LinkDown
Table 10: FortiWiFi system traps
Trap message
CPU usage high
(SysCpuHigh)
Disk low
<FortiWiFi_serial_no>
<interface_name>
HA state
HA switch
Memory low
(SysMemLow)
The <interface_name>
Interface IP is changed
to <new_IP>
(Serial No.:
<FortiWiFi_serial_no>)
(IntfIpChange)
Table 11: FortiWiFi VPN traps
Trap message
VPN tunnel is up
(VpnTunnelUp)
VPN tunnel down
(VpnTunnelDown)
01-28006-0014-20041105
Description
Standard traps as described in RFC 1215.
Description
CPU usage exceeds 90%.
On a FortiWiFi unit with a hard drive, hard drive usage exceeds 90%.
The configuration of an interface of a FortiWiFi unit changes. The
trap message includes the name of the interface and the serial
number of the FortiWiFi unit.
HA state changes. The trap message includes the previous state, the
new state and a flag indicating whether the unit is the master.
The primary unit in an HA cluster fails and is replaced with a new
primary unit.
Memory usage exceeds 90%.
The IP address of an interface of a FortiWiFi unit changes. The trap
message includes the name of the interface, the new IP address of
the interface, and the serial number of the FortiWiFi unit. This trap
can be used to track interface IP address changes for interfaces
configured with dynamic IP addresses set using DHCP or PPPoE.
Description
An IPSec VPN tunnel starts up and begins processing network
traffic.
An IPSec VPN tunnel shuts down.
System config
Fortinet Inc.