Back Of The Camera - Roboshot 12 Hdbt And Roboshot 30 Hdbt - VADDIO RoboSHOT HDBT Series Complete Manual

Complete Manual for RoboSHOT HDBT High-Performance PTZ Cameras
Back of the Camera – RoboSHOT 12 HDBT and RoboSHOT 30 HDBT
Rear panel connections are identical for the older RoboSHOT 12 HDBT and RoboSHOT 30 HDBT
cameras.
From left to right:
12 VDC, 3.0 A: EIAJ-04 jack for local power. Connect only the power supply shipped with the camera
n
or approved replacement 12 VDC, 3A power supply. This connection is not needed if you use a
OneLINK device or a PoE+ power injector.
OneLINK HDBaseT: RJ-45 connector. Connect to the network (optionally via PoE+ injector) or to a
n
OneLINK device for streaming and for control via the web interface or Telnet session.
HDMI: HDMI video output connector.
n
HD Video Resolution Select: Rotary switch to select the video output resolution. See
n
Resolution Setting.
Camera Settings: DIP switches to set camera behaviors such as IR remote frequency, baud rate and
n
image flip. See Camera Behavior Settings – RoboSHOT 12 HDBT and RoboSHOT 30 HDBT
information.
Note
A label on the bottom of the camera lists the rotary and DIP switch settings.
10
Video
for more