Camera Behavior Settings - Roboshot 12 Hdbt And Roboshot 30 Hdbt - VADDIO RoboSHOT HDBT Series Complete Manual

Complete Manual for RoboSHOT HDBT High-Performance PTZ Cameras
Camera Behavior Settings – RoboSHOT 12 HDBT and RoboSHOT 30 HDBT
Older RoboSHOT cameras use DIP switches to set camera behaviors; the RoboSHOT Elite series
cameras set all camera behaviors in the web interface.
A label on the bottom of the camera provides a quick reference for setting the switches.
Set the switches appropriately before mounting the camera.
After the camera is installed, you can read the switches from the camera's web interface.
Note
When the camera is not inverted, DIP switches are in their default positions when they are up.
(RoboSHOT 30 HDBT shown; Switch 5 is Super Wide Mode if the camera is a RoboSHOT 12 HDBT.)
IR1, IR2, IR3 (Frequency Selection): If there are multiple cameras in the room, use switches 1 and 2 to
configure each with a different IR frequency to allow the IR Remote Commander to control them
independently. Then use the Camera Select buttons at the top of the remote to select the camera you want
to control.
SW1 and SW2 up: IR frequency 1
n
SW1 down, SW2 up: IR frequency 2
n
SW1 up, SW2 down: IR frequency 3
n
IR: Leave switch 3 UP if the IR remote will be used.
Image Flip: If mounting the camera upside-down, set switch 4 DOWN: IMAGE FLIP ON.
Super Wide Mode (RoboSHOT 12 HDBT only): To use Super-wide mode, set switch 5 DOWN. This
gives 12X zoom with a 73º horizontal field of view. Normal mode provides 10X zoom with a 67.2º
horizontal field of view (HFOV).
Baud Rate: Set switch 6 to the baud rate of the RS-232-capable control device connected via OneLINK.
The default is 9600 bps. The 38400 baud setting is optional if the connected control device supports it.
Leave Switch 7 UP unless sRGB color output is needed.
For RoboSHOT 30 HDBT, Switch 5 is not used. Switch 8 is not currently used on either RoboSHOT 12
HDBT or RoboSHOT 30 HDBT.
14