Back Of The Camera - Roboshot 12 And Roboshot 30 - VADDIO RoboSHOT Series Complete Manual

Complete Manual for RoboSHOT CAT-5 Professional PTZ Camera Systems
Back of the Camera – RoboSHOT 12 and RoboSHOT 30
Rear panel connections are identical for the older RoboSHOT 12 and RoboSHOT 30 cameras.
Network Control: RJ-45 connector. Connect to the network for control via the web interface or Telnet
n
session.
HD Video Select: Rotary switch to select the video output resolution. See
n
Camera Settings: DIP switches to set camera behaviors such as IR remote frequency, baud rate and
n
image flip. See Camera Behavior Settings – RoboSHOT 12 and 30
RS-232: RJ-45 connector. Connect to the RS-232 port (if any) on the Quick-Connect device to allow an
n
external device to manage the camera using a modified VISCA protocol. See
Communication Settings
EZPower Video: RJ-45 connector. Supplies power to the camera and delivers HD video back to the
n
Quick-Connect interface using high speed differential signaling over Cat-5e cable. Connect to the
EZPower Video port on the Quick-Connect device. (Color-coded orange or yellow, depending on the
device.)
36 VDC FOR CCU ONLY: RJ-45 connector. Power from the Quick-Connect Universal CCU, in
n
RoboSHOT QCCU systems only. Do not use this port except when connecting to a Quick-Connect
Universal CCU.
Note
A label on the bottom of the camera lists the rotary and DIP switch settings.
for RS-232 settings.
16
Video Resolution
for more information.
RS-232 Serial
Setting.