Table of Contents
Advertisement
Complete Manual for RoboSHOT HDBT High-Performance PTZ Cameras
Web Interface Cheat Sheet
Where to find the camera controls you need right now.
What controls do you need?
Camera operation
Stop sending video (video mute)
n
Enter or exit standby mode
n
Camera operation
Move or zoom the camera manually
n
Move to a camera preset (Presets section, if available)
n
Select the appropriate lighting adjustments (CCU Scenes section, if
n
available)
Camera behavior and adjustments
Set or clear presets
n
Set the speed for pan, tilt, or zoom motions
n
Focus the camera
n
Work with color and lighting adjustments (CCU scenes)
n
Set motors for inverted operation (Settings button reveals the control)
n
Camera behavior settings – RoboSHOT 12E HDBT and RoboSHOT
30E HDBT
On older RoboSHOT cameras, these settings are on the rear panel DIP
switches.
IR1, IR2, IR3 (Frequency Selection) for controlling up to 3 cameras
n
independently with the remote
IR on/off for enabling/disabling control via the remote
n
Image Flip for inverted camera installation
n
Baud rate for RS-232 serial communication
n
HDMI color space (YCbCr or sRGB; default is YCbCr)
n
Advanced camera settings
Super-wide field of view (not available on 12E and 30E models)
n
Indicator light – select color scheme, enable/disable, set behavior in
n
standby mode
Codec control mode
n
Read-outs of the camera's hardware switch settings
Access management
Guest access
n
Account passwords
n
Idle session time-out
n
Telnet access enabled/disabled
n
Advanced security settings
n
IP streaming settings
Quality, resolution, and frame rate
n
RTSP streaming URL and path
n
RTMP service provider configuration
n
Network settings
(any page)
Controls (user or guest access)
or Camera (admin access)
Camera
System (DIP switches tab)
System (DIP switches tab)
System (DIP switches tab)
Security
Streaming
Networking
28
Go to this screen
Hide quick links:
Advertisement
Table of Contents
