Back Of The Camera - Roboshot 12 Hdmi And Roboshot 30 Hdmi - VADDIO RoboSHOT HDMI Series Installation Manual

Back of the Camera – RoboSHOT 12 HDMI and RoboSHOT 30 HDMI
Rear panel connectors are identical for the older RoboSHOT 12 HDMI and RoboSHOT 30 HDMI cameras.
From left to right:
Network: RJ-45 connector. Connect to the network for control via the web interface or Telnet session.
n
HD Video Select: Rotary switch to select the video output resolution. See
n
Camera Settings: DIP switches to set camera behaviors such as IR frequency, image flip (camera is
n
invertible), and baud rate. See
HDMI for more information.
RS-232: RJ-45 connector. Allows an external device to manage the camera using a modified VISCA
n
protocol. See RS-232 Serial Communication
HDMI: HDMI video output connector.
n
12 VDC, 3.0 A: EIAJ-04 jack for local power. Connect only the power supply shipped with the camera
n
or approved replacement 12 VDC, 3A power supply. This connection is not needed if you use a
OneLINK device.
Note
A label on the bottom of the camera lists the rotary and DIP switch settings.
Installation Guide for RoboSHOT HDMI High-Definition PTZ Cameras
Camera Behavior Settings – RoboSHOT 12 HDMI and RoboSHOT 30
Settings.
10
Video Resolution Setting.