Image: Roboshot 12 And 30 Rear Panel Connections - VADDIO ROBOSHOT12 Installation And User Manual

RoboSHOT HD Cameras

Image: RoboSHOT 12 and 30 Rear Panel Connections

Rear panel connections are identical for both models (RoboSHOT 12 shown).
①
②
③
1) CAMERA SETTINGS: Dip switch settings for IR remote frequency, baud rate and image flip can be configured
on these switches. See the Switch Settings page for additional information.
2) HD VIDEO SELECT: A rotary switch allows the user to choose the HD video output resolution. See the Switch
Settings page for additional information.
3) NETWORK CONTROL Port: The Ethernet 10/100 port allows the camera to be controlled from embedded
web server with a web browser or through Telnet session.
4) RS-232 Port
The RS-232 port accepts modified VISCA protocol for camera control over a Cat-5e cable. This port also acts as
an IR Forwarding port with the Quick-Connect SR or Quick-Connect DVI/HDMI interfaces, which allows the user
rd
party IR signals through camera to the head-end.
to transmit 3
5) EZ-POWER VIDEO Port: The EZ-Power Video port supplies 24 VDC power to the camera and delivers HD
video back to the Quick-Connect interface using high speed differential signaling over Cat-5e cable.
6) 36 VDC FOR CCU ONLY: The CCU power port is only used with Quick-Connect Universal CCU and is shipped
with a dust cap inserted in the connector. The RoboSHOT QDVI systems do not use this connector.
RoboSHOT HD Cameras - Document Number 342-0795 Rev A
④
⑤
⑥
Page 9 of 44