Table of Contents
Advertisement
Complete Manual for RoboSHOT HD-SDI and SDI Professional A/V Presentation Cameras
Back of the Camera – RoboSHOT 12 HD-SDI and RoboSHOT 30 HD-SDI
Rear panel connections are identical for the older RoboSHOT 12 HD-SDI and RoboSHOT 30 HD-SDI
cameras.
From left to right:
12 VDC 3.0 A: EIAJ-04 jack for local power. Connect only the power supply shipped with the camera
n
or approved replacement 12 VDC, 3A power supply. This connection is not needed if you use a PoE+
power injector.
Network PoE+: RJ-45 connector. Connect to the network for streaming and for control via the web
n
interface or Telnet session. Connect to the network via PoE+ injector for power, streaming, and control.
HD Video Select: Rotary switch to select the video output resolution. See
n
Camera Settings: DIP switches to set camera behaviors such as IR remote frequency, baud rate and
n
image flip. See
Camera Behavior Settings – RoboSHOT 12 HD-SDI and RoboSHOT 30 HD-SDI
more information.
HD-SDI: BNC connector. HD-SDI/3G-SDI video output.
n
HDMI: HDMI video output connector.
n
RS-232: RJ-45 connector. Connect to an external device to manage the camera using a modified
n
VISCA protocol. See
Note
A label on the bottom of the camera lists the rotary and DIP switch settings.
RS-232 Serial Communication Settings
for cable pin-out and settings.
7
Video Resolution
Setting.
for
Hide quick links:
Advertisement
Table of Contents
