Installing The Camera - VADDIO RoboSHOT HDBT Series Complete Manual

Complete Manual for RoboSHOT HDBT High-Performance PTZ Cameras

Installing the Camera

Be sure you have already set the camera's switches.
Caution
Check your cables. Connecting a cable to the wrong port or using the wrong pin-out can result in equipment
damage and will void the warranty.
1. Route the cables to the camera location.
2. Route the cables through the mount, and install the mount on the wall or attach it to the wall box. Leave
the screws loose enough to adjust the position of the mount.
3. Level the mount and tighten the mounting screws.
4. Connect the cables to the camera.
Caution
If using local power rather than connecting to a OneLINK extension module or using PoE+, use the
power supply shipped with the camera. Using a different power supply may create an unsafe operating
condition or damage the camera, and will void the warranty.
Caution
5. Place the camera on the mount.
6. Attach the camera to the mount using the ¼"-20 x .375 mounting screw supplied with the camera.
Images for illustration only; not to scale. Camera and mount details may differ.
21