CAIRE 1000B Provider Technical Maunal page 87

Personal Ambulatory Oxygen System Provider Technical Manual
1.7 Unbox the SP5932-1-SEQ and account for all parts (Fig 67).
Fig 67: New Power Manager
1.8 Position the New Power Manager PCB(PN: 5932-1-SEQ) 1" out of the case as shown in Fig 58. Gently push the Compressor Box away
from the Power Manager pcb by 1/8". Connect the 2 wire harnesses (Ext Power & ATF harness) and the Control Board Ribbon Cable.
Note: Route the wiring under the edge of the compressor. Position the Power Manager PCB into the alignment slots on the back case.
Finally connect the 9V batt wiring harness (between the exhaust & battery compartment) and 3 Compressor wiring harnesses to their
connectors.
Fig 68: Routing Wires
87