2) Position the product tank with the 2 hose barbs facing in the direction of the ATF. Refer to Figure 46.
3) Install the securing arm over the product tank, and locate the screw hole on the back case cover for the old product tank
securing arm that was to the right(top side of compressor). See Figure 47.
4) Locate the Product Tube - remove black ATF outlet barb cap, and attach the Product Tube Assy to the ATF output barb,
secure with a cable tie. Attach the other end of the Product Tube to the Bottom port on the Product Tank.
Personal Ambulatory Oxygen System Provider Technical Manual
Figure 46: Product tank and hose barbs
Install securing arm
and install two screws
Figure 47: Install securing arms
73