ABB ACS2000 AFE 1MVA User Manual page 145

145 ACS2000 AFE 1MVA UM 3BHS297030 ZAB E01 REV. J
—
9.8 Drive selection mode
9.8.1 Overview
The drive selection mode is used to connect the
CDP control panel either to the AMC circuit board
of the AFE or the INU of the drive.
—
In this context, the AMC circuit
board of the AFE and INU is
referred to as a drive that is iden-
tified in the control system by its
ID number:
• ID number of INU: 1
• ID number of AFE: 2
Status line
1
Device type
2
Application SW version
3
Drive identification
4
Selection key for drive mode
5
1
ACS2000 AFE
2
6k SingleINU
3
LDAI5500
4
ID-Number 1
6
Slow navigation key for selecting the AMC cir-
6
cuit board (AFE or INU)
Enter key for confirming the selection
7
9.8.2 Selecting an AMC circuit board
—
It is assumed in the following
example that the CDP control
panel is connected to the INU.
1. To enter the drive mode, press the DRIVE key.
2. To select the ID number of the AFE and to con-
nect the CDP control panel to the AFE, press any
of the slow navigation keys.
5
7
If none of the keys is pressed, the display automat-
ically returns to the actual signals display after a
while.
If the ID number of the AFE or INU is changed by
accident (eg, to 3) and the ENTER key has been
pressed, the new number is saved in the memory.
The display still shows the old number. Only when
the auxiliary voltage has been switched off and on
again, the new number is shown on the display.
If the ID number is changed by accident, simply
change the ID number back and press the ENTER
key. The ID number is restored when the auxiliary
power is switched off and on the next time.
ACS2000AD
6k SingleINU
LDAI5500
1
ID-Number
ACS2000AFE
6k SingleAFE
LBAI5120
2
ID-Number