ABB ACS2000 AFE 1MVA User Manual page 137

137 ACS2000 AFE 1MVA UM 3BHS297030 ZAB E01 REV. J
—
9.5 Actual signals mode
9.5.1 Overview
Two displays can be selected in the actual signals
mode:
• Actual signals display
• Fault memory display
The actual signals display appears first when
entering the actual signals mode. However, when
the drive is in a fault condition, the fault memory
display appears instead.
The actual signals display is used to monitor the
drive without interfering with its operation. It con-
tinuously displays three selectable actual values..
The CDP control panel automatically returns to the
actual signals display from other modes if no key is
actuated within one minute (an exception from
this is the fault memory display).
Actual values
The actual values are organized in groups.
Group 01
Group 02
Group 03
Group 04
Group 05
Group 06
Group 07
Group 08
Group 09
Fault memory
The fault memory display provides information on
the 64 most recent fault events that occurred in
the drive. It displays the name of the fault and the
time it occurred. For instructions on how to display
and reset the fault memory, see
and resetting an active
When the drive generates a fault or alarm, the cor-
responding message displays immediately.
Changing from the fault memory mode to other
modes is possible without resetting the fault first.
When no keys is actuated, the fault or warning text
is displayed as long as the fault is active.
Measured or calculated motor values
Measured or calculated drive values
Reference values
I/O status signals
Communication link and MCB status signals
Software version, drive and motor nominal
values
Control words
Status words
Fault and alarm words
For the complete list of selectable actual
signals, see signal and parameter table
9.5.7 Displaying
fault.
Control panel overview
1 L -> 600.0 rpm
ReadyOn
StateINU
MOTOR SP 0.00 rpm
POWER 0.0 kW
3
4
5
Status line
1
Actual signal names and values
2
Selection key for actual signals mode
3
Fast navigation key for selecting the actual sig-
4
nals display or the fault memory display
.
Slow navigation key for selecting signals or fault
5
messages
Enter key for confirming the selection
6
1
2
6