ABB ACS2000 AFE 1MVA User Manual page 140

CHAPTER 9 – CDP CONTROL PANEL
—
9.6 Parameters mode
NOTICE
Running the drive system with incorrect data can
result in improper operation, reduction of control
accuracy and damage to equipment.
Parameters must only be set by qualified
personnel. Do not change any parameter, if the
meaning of the parameter and the effects of the
change are not fully understood.
Group 07
Group 08
Group 09
Group 11
Group 12
Group 16
Group 17
Group 18
Group 19
Group 20
Group 21
Group 22
Group 23
When entering the parameters mode for the first
time after the auxiliary supply voltage of the drive
has been switched on, the CDP control panel dis-
plays the first parameter of parameter group 11.
The next time the parameters mode is entered, the
previously selected parameter displays.
Some parameter values cannot be changed while
the drive is running. If tried, the following warning
displays.
**
Control words
Status words
Fault and alarm words
Start / stop / direction / MCB control
Reference selection
System control inputs
DC-link control
Utility
Data storage
Limits
Start / stop / process stop
Ramp functions
Speed reference
For further information on the parame-
ters, their settings and functions, see
Appendix G – Signal and parameter table.
WARNING
**
WRITE ACCESS DENIED
PARAMETER SETTING
NOT POSSIBLE
9.6.1 Overview
If the parameter lock is disabled or unlocked (see
9.6.3 Enabling / unlocking a parameter
parameters mode allows entering the parameter
settings for the required drive configuration
depending on the application.
The parameters are organized in functional
groups, so called parameter groups.
21.01 Start function
21.02 Start function
21.03 Off1 stop mode
21.04 Process stop selection
21.05 Process stop signal
21.06 Process stop MCB control
21.07 Process stop mode
.
.
.
21.17
MCB closing time limi
21.17
21.19 MCB available signal
140
lock), the
t