Table of Contents
Advertisement
MultiGene Thermal Cycler
the unit.
6.
Slide the new block into place and connect the plug.
7.
Gently slide the block until the two screw holes are lined up.
8.
Replace the two screws and plugs.
9.
Shut the face panel and secure it with two screws.
Troubleshooting
Problem
The display is off even when
power is switched on.
Can't reach 4°C.
Cycle time is too long
Lid heater does not work.
No key entry sound.
The display goes off.
Cause
1. Power is not reaching the
system.
2. Power
cord
plugged into the socket
properly.
3. Power fuse is blown out.
4. Block fuse is blown out.
1. Operating
temperature
environment
may
unsuitable.
2. Electronic
element may be damaged
or aged.
1. Operating
environment
temperature
may
unsuitable.
2. Electronic
element may be damaged
or aged.
3. Faulty temp. sensor.
1. Lid heater is set off.
2. Lid sensor problem
1. Sound may currently be
set off.
2. Faulty keys or keypad
wiring.
1. Faulty backlight.
31
Action
1. Check
voltage.
is
not
2. Reconnect
cord.
3. Replace the power fuse.
4. Return
service.
1. Operate the unit in a
be
environment
between 15 to 30 °C.
cooling
2. Return
service.
1. Operate the system in a
be
temperature
between 15 to 30 °C.
cooling
2. Return
service.
3. Return
service.
1. Check Lid Temperature
setting in System Mode.
2. Return
service.
1. Check Beeper setting in
System Mode.
2. Return
service.
1. Check the LCD contrast.
power
source
the
power
the
unit
for
temperature
the
unit
for
environment
the
unit
for
the
unit
for
the
unit
for
the
unit
for
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the MultiGene OptiMax TC9610 and is the answer not in the manual?
Questions and answers